|
Fitting Instructions For New Thermal Beads
Bring a cup of water almost to a boil in microwave (1-3min depending on its power), remove cup from microwave and pour beads into water. Once the beads have turned CLEAR (about 1 min depending on the water temperature) remove beads WITH A SPOON.
Using your fingers, quickly mould the clear plastic into a “worm shape”.
Place the clear plastic material in the “trough” portion of the teeth, squeeze with your fingers a small bit of the clear plastic through the three holes.
IMPORTANT. DURING THE REMAINING FITTING PROCESS DO NOT LEAVE THE TEETH IN YOUR MOUTH FOR MORE THAN 30 SECONDS OR LET THE FITTING BEADS COOL AND SET IN YOUR MOUTH
Place the teeth in your mouth and ease your teeth down through the clear fitting plastic until you hit the bottom.
Using your tongue, push the excess clear plastic against the roof of your mouth and suck the teeth tightly to your own teeth so that you have a firm impression in the clear fitting plastic. (Remember to take no more than 30 seconds)
Gently remove the teeth and let them cool for 10 minutes. Notice that when the fitting plastic cools it turns white again.
If you mess up, reheat and try again as needed. Trim away any excess fitting plastic.
Always rinse your Billy-Bobs with cold water after use and allow to dry.
|
 |
